I ran a cross a reference somewhere about an extended gas nozzle for a
spool
gun. They touted it as a way to reach into close quarters to make a weld.
I can't imagine how that would work unless it also included an extended
length tip to match. Anybody have any experience with this? There is one
location on my current project where I would like to double weld from both
sides where I have a band-aid weld on the outside. The seam is filled on
the inside most of the way, but no matter how I hold my gun I can't get a
good angle on the last couple inches. Its probably not critical, but its
comes up to a hard corner, and stresses seem to magnify at hard points.
The
regular gun could reach in there, but I am not crazy about running
aluminum
down that long hose. I have enough trouble keeping everything going
right
with the spool gun.
