I bought some plasma cut pieces at a fair recently. They were cut with a
Dyna torch, and they have quite a bit of dross on the backside. The cuts
are small, as the pieces are about a square foot apiece. I will have to
take a grinder and carefully take the dross off, sometimes having
difficulty
getting into the spaces. I have an air grinder I can use, too, but that
jumps badly when it gets into tight places. I was thinking of using a
belt
sander on the back. Any easy way to get all the dross off in those small
cracks?
Steve
--
-Never underestimate the power of stupid people in large numbers.-
